Plumbing

Tips to Improve the Lifespan Of Your Hot Water Heater

2 Mins read

In most cases, our water heaters go unnoticed in our homes. We don’t spend nearly as much time learning about or maintaining them as we do with our air conditioners and other more common house repairs.

On the other hand, the water heater system is equally important and requires routine maintenance if you want to get the most years out of it. Even the best water heaters will fail prematurely if not properly maintained. The lifespan of a water heater is determined by the amount of time and effort invested in it. However, running a water heater is a difficult task.

Many people in Adelaide buy a traditional tank water heater and then forget about it until it breaks down and needs to be replaced. However, by following a few basic water heater maintenance steps, you can extend the unit’s life and improve its efficiency.

If you’re having trouble getting your hot water to last longer while showering, just try these tips.

Once a year, flush the water heating tank.

Almost every water heater manufacturer will advise flushing the tank once a year. However, simply draining the water heater will not flush it!

Draining your water heater should be done according to the manufacturer’s instructions. These are the instructions for a Bradford White water heater, for example: To flush the water heater, follow these Steps:

  • If you’re using a gas water heater, turn off the gas valve.
  • Turn off the cold water supply on the water heater.
  • On the hot water faucet, turn it on.
  • Connect a hose to the drain valve on the heater and direct it to a drain.
  • By opening the drain valve, you can drain the tank completely.
  • Turn on the cold water to restart the water heater.
  • To allow the tank to refill, close the drain valve and leave the hot water faucet open. The tank is full when water comes out of the faucet.

Check the Anode Rod and Replace it if it’s Badly Corroded

The anode rod is suspended in the tank to prevent the inside from rusting. When the tank is drained, it should be tested once a year. It is much less expensive to replace a poorly corroded rod than it is to replace the water heater. Without a good anode rod, hot water will easily corrode the inside of the tank, shortening its life.

Insulate the Hot Water Heater Tank.

You only need to complete this step once. An insulation blanket wrapped around your water heater will boost its efficiency by up to 40%. Over the course of a year, that 40% will save you a lot of money on your utility bills.

Conclusion: Be proactive about maintaining the heaters of hot water in Adelaide in your home rather than just assuming it will always function when you need it. This will not only save you money, but it will also save you from massive headaches in the future.